Fellow Products

My old one finally died after years of use, so I grabbed this as a direct replacement. Fit perfectly into the kettle's grommet and the numbers are easy to read even from across the kitchen.

The temperature readings are spot-on compared to my old probe, and it clicks right into place without any wiggling. Had no trouble swapping it out in under a minute.

Fits my kettle perfectly — the probe is a bit longer than the original, which actually makes it easier to read the temperature while the lid is on.

Was a bit worried about getting the right size, but the mounting threads matched exactly and the probe is just as responsive as the original. Works like a charm with no leaks, so my kettle's back in action.

Fits perfectly in my old kettle and the temperature readout is spot-on compared to my instant-read probe. No more guessing when the water’s ready for pour-over coffee.

I was pleasantly surprised by how accurate this thermometer is—my water hits exactly 212°F every time now. The clip attached securely without any wobbling, which was a nice upgrade from my old one.

Swapped out the old one on my Raven kettle in about five minutes with just a screwdriver. The markings are clean and easy to read even from across the kitchen. It’s a simple fix, but the temperature readings seem accurate so far.

Swapped out the old thermometer on my kettle and this one fit perfectly, reading accurately from the start. The screw holes lined up without any fuss, which was a relief. Only wish the plastic trim matched the original a bit better, but it works fine.

Used this to replace the broken thermometer on my gooseneck kettle and it fit perfectly, no adapter needed. Reads consistently within a degree or two of my Thermapen.

It fits perfectly on my old kettle and reads accurately compared to my other oven thermometer. The only minor issue is the clip could be a bit sturdier, but it hasn’t fallen off yet.